Heat Transfer Questions & Answers  
Question by Student 201327139
Professor, I wonder about 'Summary of eqs for flow over flat plate' table. When flow regime is Laminar, local, we have another 2 restriction, same condition of \( Re_x<5*10^5, 0.6<P_r<50 \) and ' \( T_w=const \)' / ' \( q_w=const \)'. What's the difference of two condition? What should I use between two condition? Thank you.
05.14.18
Well, you should use the ${\rm Nu}_x$ expression that says $T_{\rm w}$ is constant when the wall temperature over the entire plate is a constant. And you should use the ${\rm Nu}_x$ expression that says $q^"$ is constant when the heat flux at any location on the flat plate is constant. 0.5 point bonus.
Question by Student 201427126
I ask a question about assignment 7-2. In this problem, i want to find the density for film temperature. I think there are two ways. First, get through table “properties of air at atmospheric pressure” Second, it is obtained through an ideal gas equation. What is correct? What’s the difference?
05.18.18
In this case there is no difference because the air pressure is 1 atm.
Question by Student 201427126
I have solved both two methods. But there is a difference in value. The difference is not great, but i think that an appropriate choice is needed to reduce the error of the answer. What should i use for this problem, and if the pressure is not 1 atm, which of the two methods is appropriate? And why?
656B0421-E956-4E26-8C65-E7928AA29476.jpeg    
05.19.18
Please write your equations using , not using a scan. Scans should be used for schematics. Post your complete question again below using and I will answer it.
Question by Student 201527110
Professor, in my opinion it'll be better to use film temperature density $\rho_f$ in the mass conservation $\dot{m}_1=\dot{m}_2$ what we used in lecture to get maximum velocity $u_{max}$ for higher accuracy answer in the case of tube banks. In the lecture, you dervived it with same density as $\rho_\infty$ but if the temperature is risen by the tubes, density will be changed automatically and even also we consider it as a film temperature $T_f$ properties like $\rho_f,k_f, ETC$. Or the error accured by using $\rho_\infty$ in mass conservation is acceptable in this case?
05.21.18
You need to analyze the problem a bit more. Please find an estimate of the height of the thermal layer and compare it to the distance between cylinders. Is this ratio high or low? Do so below, I'll reward you for sharing your efforts with the class.
Previous   1  ...  32 ,  33 ,  34   •  PDF 1✕1 2✕1 2✕2
$\pi$